Digital receiver. 9 inputs. With 2 S-video inputs. Built in tuner. Unit has seen low use. Nice design. New heavy duty 10A. Relay. Resolder p.s. regulators. Board connect. 9 condition.
No output transistors (available listed separately on website), driver board and heat sync assembly (board only can be shipped if preferred), intact complete, was taken from working unit, all capacitors appear to test ok, Low use stored for 20 years.
BE71i-0001. Large black transformer with board mount. 8+/10 condition, pulled from SX-1280 Stereo receiver.
Board #AWG060-0. Front panel switch board for muting, volume, balance, loudness, mode, adapter, and tape functions. (from right to left). Two rotary switches with appropriate nuts and washers. 9/10 condition, fully functioning and good condition, pulled from used machine.
Board #157BIXK. Power supply board. 8+/10 condition
Check us out on facebook.
amp and CD player, CD player is problematic, amp works, selling as is for parts
Board #AWG0590. Front panel switch board for treble 20/10KHZ, tone, bass 100/50KHZ (from right to left). Four rotary switches with appropriate nuts and washers. 8+/10 condition, fully functioning and good condition, pulled from used machine.
4/2 channel receiver. No output on 3 of 4 channels - likely bad quad chip (TR09032). FM works, all bulbs OK. Has known troublesome caps (blue Sanyo). Has 4 PA-401 hybrids ICs, amplifier IC TR09027, TR09018 FM IC. Mechanically intact, wood case in good condition; missing bass/treble knobs. Will sell as individual parts or as a whole machine (with the caveat that it needs TLC). Condition: 8
Two special, rare to find, high power audio transistors. Only version A are now available. 2SD747A, 2SB706A.
Top and Bottom Cover for Marantz 2270 receiver. In good #7 condition with some minor wear.
set of original parts: (1) 25C732, (1) 25C373, (1) 25A497, (1) 25C497, (2) 25D257, (1) 2000μf cap, (2) emitter resistors, (4) thermal diodes salvage test all good #8
Re: International Shipping: We ship internationally often and have yet to encounter a problem or complaint. We are very careful to test the equipment before it’s packed and then to double box the machine with added protection when needed for front panels, etc. We are not amateurs or an ebay store; we know these machines very well and know what it takes to get them to you safely. We use USPS priority internationally which seems to be the cheapest. If you prefer another carrier (you should know who delivers to your area reliably) please let us know. Also please be aware of any tariffs that you may be responsible for upon pick up on your end. International shipping may be expensive but we will make sure it is not a headache on top of the cost. PLEASE NOTE THAT SHIPPING INTERNATIONALLY WILL BE A MINIMUM OF $16 EVEN FOR SMALL PARTS.
1-129-11 10k3bx210k1b ALPS potentiometers. Complete board assembly with headphone jack. Excellent condition.
possibly for SX680, SX750, SX630? Board is tested and working, but sold as is, in need of some capacitor replacements.
(1) Power switch. Special high current 6A/96A250V. 10 condition (new).
(possibly for SX 828, 949), 6 ct. - lever switch knobs, 4 ct. - function/selection knobs, 2 ct. - concentric (right/left) knobs, 1 ct. - tuning knob with 2 set screws, due to slight age look - can be cleaned up, #8+ condition
Yamaha CD Player -$24.00 - walnut cabinet in 8+ condition -$ 18.00 - all aluminum knobs in 8 condition -boards and assembly available as parts CALL - in #8+ cosmetic condition, mechanically needs servicing (bad FM circuit)
Stereo receiver. Can be serviced/restored. Loose bottom panel (no screws). No side panels/top panel. For parts or full repair. condition #6
If you are having trouble finding parts, enter the name into our search bar at the top of the page. Please be aware there is a minimum $4-$6 to ship any part. International orders will be $14-$16 to ship for anything larger than an envelope. Shipping costs are non negotiable, so please, PLEASE do not ask for a part, or for us to search for, or quantify a part if you cannot pay for the shipping.
Amplifier board #EB 2291, used- good condition (pulled from working unit), capacitors should be replaced to be reliable. #8 condition
Auto/Manual tuning options, Battery powered (2x9v), Unit in good shape (minor scratches)
Parts unit that has seen a lot of use, and has swollen caps and bad bulbs. Face and knobs are intact. Possible shorted output transistors; unit draws a large current. Cosmetics, mechanicals, and knobs are good (#8+), but vinyl cover is poor (#7).
high quality. New stock.
currently mounted on PCB 1-673-043-11, but can be removed upon customer request. Excellent condition.
All Remotes are now 25% off or Free Shipping!!! (Reel to Reel remotes excluded).
Test, low use. Condition #9
Volume control and board. 7120 526 M motorized control. W/ICS, LC7522, (2)LA3607. Condition #9