Many of these amps available, Intact but all have problems, some bad amp circuits, caps, transistors on plug in driver board. Most have OK output transistors. #6 condition.
Power amplifier, 150 watts/channel/8ohm. Unit has an open transformer. But is in good condition cosmetically. Soft clipping circuit on/off switch 2 speaker outputs Inputs: RCA Fixed or variable level. Can be run stereo or mono with bridge switch. #7 condition due to open transformer. Please call if interested
Right channel missing parts. No obvious shorts on outputs. Previous service by another shop caused the damage. Definitely rebuild-able low use machine. #7 Condition.
Integrated amp, amps will not turn on, appears to be low level power supply problem forces unit into protect, amplifier modules seem to be ok. Good condition #8
*This is a parts unit, sold AS-IS* Many capacitors in unit are bad & Will need replacing. Some parts already replaced in previous repair attempt, will need more work to operate fully. Unit could be repaired or used as parts for another similar unit. Unit is missing one barrel fuse twist-lock cover on the back. Units "unswitched" AC connector on back is cracked. Faceplate is aged/ worn but not terribly damaged. Some knobs are missing caps. Case has scratching & many points of wear. Cosmetically OK with obvious wear/ use. Being sold AS-IS for parts or repair. #7 condition
5/16" spacing between pins on input to unit. Black color cable. Excellent condition. (Read listing carefully KLH made 4 variations of AC cords) Please show us a picture of your AC connector to guarantee proper fit replacement. M. P. W.
2-prong AC cord (white) 5/16" pin spacing (read listing carefully KLH made 4 variations of AC cords)#8 condition. (2) available*** Unfortunately 3 prong connector version is not available presently. *** It's the rarest one. Try a hardware store, sometimes by luck it can be found there, but three variations of these exist and it must match your unit. If you get desperate to get it running, we will install / adapt another cord. We can do service on these machines. COULD NOT FIND PAPERWORK
80v power supply capacitor, screw post mounting (1+1/8" c to c), 2. 5"w x 3+1/8"h. 1987 production, excellent condition, two pieces available. Parts Sold Paperwork not found
Fits 1060 amp series + tuners (105), walnut veneer, has many obvious scratches but appears to be repairable with skim sanding and refinish, but will probably still show slight scuffs, #7 condition
All motors are tested for torque and oiled where required. We have prepared years ago to find and salvage parts to help repair nice older equipment.
Yamaha M-80 face plate
# 61668
Face plate only, has small scrapes/scratches on the left hand edge, can be sanded out, includes push buttons (power, auto class A, peak hold, range 2, 4, 8 Ω load), good condition, #8+
Power amplifier, right channel good, left channel bad *not an obvious fault (difficult to trouble shoot this design- requires replacement module), parts unit, good cosmetic condition for right channel module, low use condition, perfect cosmetic 9.
